Broadband field-enhancement in epsilon-near-zero photonic gap antennas
Authors:
Félix Thouin,
David M. Myers,
Ashutosh Patri,
Bill Baloukas,
Ludvik Martinu,
Stéphane Kéna-Cohen
Abstract:
In recent years, the large electric field enhancement and tight spatial confinement supported by the so-called epsilon-near-zero (ENZ) mode have attracted significant attention for the realization of efficient nonlinear optical devices. Here, we experimentally demonstrate a new type of antenna, termed an ENZ photonic gap antenna (PGA), which consists of a dielectric pillar within which a thin slab…
▽ More
In recent years, the large electric field enhancement and tight spatial confinement supported by the so-called epsilon-near-zero (ENZ) mode have attracted significant attention for the realization of efficient nonlinear optical devices. Here, we experimentally demonstrate a new type of antenna, termed an ENZ photonic gap antenna (PGA), which consists of a dielectric pillar within which a thin slab of indium tin oxide (ITO) material is embedded. In ENZ PGAs, hybrid dielectric-ENZ modes emerge from strong coupling between the dielectric antenna modes and the ENZ bulk plasmon resonance. These hybrid modes efficiently couple to free space and allow for large enhancements of the incident electric field over nearly an octave bandwidth, without the stringent lateral nanofabrication requirements required by conventional plasmonic or dielectric nanoantennas. The linear response of single ENZ PGAs is probed using dark field scattering and interpreted using a simple coupled oscillator framework. Third harmonic generation is used to probe the field enhancement and large enhancements are observed in the THG efficiency over a broad spectral range. This proof of concept demonstrates the potential of ENZ PGAs, which we have previously shown can support electric field enhancements of up to 100--200X, which is comparable with those of the best plasmonic antennas.
△ Less
Submitted 9 November, 2022;
originally announced November 2022.
Exploration of co-sputtered Ta$_2$O$_5$-ZrO$_2$ thin films for gravitational-wave detectors
Authors:
M. Abernathy,
A. Amato,
A. Ananyeva,
S. Angelova,
B. Baloukas,
R. Bassiri,
G. Billingsley,
R Birney,
G. Cagnoli,
M. Canepa,
M. Coulon,
J. Degallaix,
A. Di Michele,
M. A. Fazio,
M. M. Fejer,
D. Forest,
C. Gier,
M. Granata,
A. M. Gretarsson,
E. M. Gretarsson,
E. Gustafson,
E. J. Hough,
M. Irving,
É. Lalande,
C. Lévesque
, et al. (23 additional authors not shown)
Abstract:
We report on the development and extensive characterization of co-sputtered tantala-zirconia thin films, with the goal to decrease coating Brownian noise in present and future gravitational-wave detectors. We tested a variety of sputtering processes of different energies and deposition rates, and we considered the effect of different values of cation ratio $η=$ Zr/(Zr+Ta) and of post-deposition he…
▽ More
We report on the development and extensive characterization of co-sputtered tantala-zirconia thin films, with the goal to decrease coating Brownian noise in present and future gravitational-wave detectors. We tested a variety of sputtering processes of different energies and deposition rates, and we considered the effect of different values of cation ratio $η=$ Zr/(Zr+Ta) and of post-deposition heat treatment temperature $T_a$ on the optical and mechanical properties of the films. Co-sputtered zirconia proved to be an efficient way to frustrate crystallization in tantala thin films, allowing for a substantial increase of the maximum annealing temperature and hence for a decrease of coating mechanical loss. The lowest average coating loss was observed for an ion-beam sputtered sample with $η= 0.485 \pm 0.004$ annealed at 800 $^{\circ}$C, yielding $\overline{\varphi} = 1.8 \times 10^{-4}$. All coating samples showed cracks after annealing. Although in principle our measurements are sensitive to such defects, we found no evidence that our results were affected. The issue could be solved, at least for ion-beam sputtered coatings, by decreasing heating and cooling rates down to 7 $^{\circ}$C/h. While we observed as little optical absorption as in the coatings of current gravitational-wave interferometers (0.5 parts per million), further development will be needed to decrease light scattering and avoid the formation of defects upon annealing.
△ Less
Submitted 25 March, 2021;
originally announced March 2021.
