Determination of the speed of light from the longitudinal modes beat frequencies of an open-cavity helium-neon laser
Authors:
Mohamad Taim,
Nicholas Kuder
Abstract:
We empirically determined the speed of light by measuring the variation in longitudinal mode frequencies, or the beat frequencies, of an adjustable-length, open-cavity helium-neon laser as a function of its cavity length. The TEM$_{00}$ mode lasing output of the laser was analyzed using a fast frequency photodiode detector and a radio frequency spectrum analyzer. A Fabry-Perot interferometer was u…
▽ More
We empirically determined the speed of light by measuring the variation in longitudinal mode frequencies, or the beat frequencies, of an adjustable-length, open-cavity helium-neon laser as a function of its cavity length. The TEM$_{00}$ mode lasing output of the laser was analyzed using a fast frequency photodiode detector and a radio frequency spectrum analyzer. A Fabry-Perot interferometer was used to monitor the intensity of the longitudinal modes and we found that the phenomena of frequency pushing and pulling had little effects on the beat frequency measurements. Plotting the reciprocal of the beat frequency as a function of the change in cavity length, the speed of light was found, by using linear weighted least squares regression, to be $(2.997 \pm 0.003) \times 10^{8}$ ms$^{-1}$. This value is $0.3 σ$ away from the defined value of speed of light and is accurate to 1 part in 3200.
△ Less
Submitted 7 May, 2021;
originally announced May 2021.
Design and Vertical Tests of SPS-series Double-Quarter Wave (DQW) Cavity Prototypes for the HL-LHC Crab Cavity System
Authors:
S. Verdú-Andrés,
K. Artoos,
S. Belomestnykh,
I. Ben-Zvi,
C. Boulware,
G. Burt,
R. Calaga,
O. Capatina,
F. Carra,
A. Castilla,
W. Clemens,
T. Grimm,
N. Kuder,
R. Leuxe,
Z. Li,
E. A. McEwen,
H. Park,
T. Powers,
A. Ratti,
N. Shipman,
J. Skaritka,
Q. Wu,
B. P. Xiao,
J. Yancey,
C. Zanoni
Abstract:
Crab crossing is essential for high-luminosity colliders. The High Luminosity Large Hadron Collider (HL-LHC) will equip one of its Interaction Points (IP1) with Double-Quarter Wave (DQW) crab cavities. A DQW cavity is a new generation of deflecting RF cavities that stands out for its compactness and broad frequency separation between fundamental and first high-order modes. The deflecting kick is p…
▽ More
Crab crossing is essential for high-luminosity colliders. The High Luminosity Large Hadron Collider (HL-LHC) will equip one of its Interaction Points (IP1) with Double-Quarter Wave (DQW) crab cavities. A DQW cavity is a new generation of deflecting RF cavities that stands out for its compactness and broad frequency separation between fundamental and first high-order modes. The deflecting kick is provided by its fundamental mode. Each HL-LHC DQW cavity shall provide a nominal deflecting voltage of 3.4 MV, although up to 5.0 MV may be required. A Proof-of-Principle (PoP) DQW cavity was limited by quench at 4.6 MV. This paper describes a new, highly optimized cavity, designated DQW SPS-series, which satisfies dimensional, cryogenic, manufacturing and impedance requirements for beam tests at SPS and operation in LHC. Two prototypes of this DQW SPS-series were fabricated by US industry and cold tested after following conventional SRF surface treatment. Both units outperformed the PoP cavity, reaching a deflecting voltage of 5.3-5.9 MV. This voltage - the highest reached by a DQW cavity - is well beyond the nominal voltage of 3.4 MV and may even operate at the ultimate voltage of 5.0MVwith sufficient margin. This paper covers fabrication, surface preparation and cryogenic RF test results and implications.
△ Less
Submitted 21 May, 2018;
originally announced May 2018.
