This article needs additional citations for verification. (September 2008) |
Rail directions are used to describe train directions on rail systems. The terms used may be derived from such sources as compass directions, altitude directions, or other directions. These directions are often specific to system, country, or region.
Radial directions
editMany rail systems use the concept of a centre (usually a major city) to define rail directions.
Up and down
editIn British practice, railway directions are usually described as "up" and "down", with "up" being towards a major location. This convention is applied not only to the trains and the tracks, but also to items of lineside equipment and to areas near a track. Since British trains run on the left, the "up" side of a line is usually on the left when proceeding in the "up" direction.
On most of the network, "up" is the direction towards London. In most of Scotland, with the exception of the West and East Coast Main Lines, and the Borders Railway, "up" is towards Edinburgh. The Valley Lines network around Cardiff has its own peculiar usage, relating to the literal meaning of travelling "up" and "down" the valley. On the former Midland Railway "up" was towards Derby. On the Northern Ireland Railways network, "up" generally means toward Belfast (the specific zero milepost varying from line to line); except for cross-border services to Dublin, where Belfast is "down". Mileposts normally increase in the "down" direction, but there are exceptions, such as the Trowbridge line between Bathampton Junction and Hawkeridge Junction, where mileage increases in the "up" direction.[1]
Individual tracks will have their own names, such as Up Main or Down Loop. Trains running towards London are normally referred to as "up" trains, and those away from London as "down". Hence the down Night Riviera runs to Penzance and the up Flying Scotsman to London King's Cross.[citation needed] This distinction is less meaningful for trains not travelling towards or away from London; for instance a CrossCountry train from Manchester to Bournemouth uses "up" lines as far as Reading and "down" lines thereafter.
In China, railway directions with terminus in Beijing are described as "up" (
In Japan, railway directions are referred to as "up" (
In Hong Kong, most lines have their "down" direction towards the terminal closer to Central, with the exception of Disneyland Resort line, where the down line is towards Disneyland to be consistent with Tung Chung line where it branches from. On Tuen Ma line, the "down" end is Wu Kai Sha. The up/down direction was switched in the former Ma On Shan line such that it could be connected with the former West Rail line.[4] The direction is signposted along the track, with the mileage increasing in the up direction, and also on the platform ends.
The railway systems of the Australian states have generally followed the practices of railways in the United Kingdom. Railway directions are usually described as "up" and "down", with "up" being towards the major location in most states, which is usually the capital city of the state. In New South Wales, trains running away from Sydney are "down" trains, while in Victoria, trains running away from Melbourne are "down" trains. An interstate train travelling from Sydney to Melbourne is a "down" train until it crosses the state border at Albury, where it changes its classification to an "up" train. Even in states that follow this practice, exceptions exist for individual lines. In the state of Queensland, "up" and "down" directions are individually defined for each line. Therefore, a train heading towards the main railway station in Brisbane (Roma Street station) would be classified as an "up" train on some lines but as a "down" train on other lines.[5] In South Australia, there are two (2) up/down origins: Port Augusta and Adelaide.
In Taiwan, trains travelling north towards Keelung on the west-coast Main Line and towards Badu on the Yilan Line are considered "up" trains. However, on other parts of the network, the terminology "clockwise" and "counter-clockwise" is used instead.
Inbound and outbound
editIn many commuter rail and rapid transit services in the United States, the rail directions are related to the location of the city centre. The term inbound is used for the direction leading in toward the city centre and outbound is used for the opposite direction leading out of the city centre.[6][7]
City name directions
editSome British rail directions commonly used are London and Country. The London end of a station platform or train is the end nearer to London. First class accommodation, where provided, is usually at this end. The country end is the opposite end. This usage is problematic where more than one route to London exists (e.g. at Exeter St Davids via Salisbury or Bristol, or Edinburgh Waverley).
Even and odd
editIn France, railway directions are usually described as Pair and Impair (meaning Even and Odd), corresponding to Up and Down in the British system. Pair means heading toward Paris, and Impair means heading away from Paris. This convention is applied not only to the trains and the tracks, but also to items of lineside equipment. Pair is also quasi-homophonic with Paris, so direction P is equivalent either with direction Pair or with direction Paris.
A similar system is in use in Italy, where directions can be Pari or Dispari (Even and Odd respectively). Pari (Even) trains conventionally travel north- and west-bound. The city of Paris is referenced in colloquial use (Parigi in Italian), with Pari trains virtually leading towards it (Paris being in a north-western direction from any point in Italy).
Polish railways also use parzysty and nieparzysty (even and odd) to designate line directions, with odd directions usually heading away from major cities (with historical exceptions in place) and thus functionally the equivalent of the British "down" direction. The odd direction is the direction of increasing mileage. With rail traffic in Poland operating on the right-hand side, down/odd tracks are usually on the right on double-track lines, and signalling equipment numbering follows this. Train numbers adhere to this directional principle to the extreme: trains entering a line in opposite direction of their previous line will change numbers accordingly (with numbering pairs: 0/1, 2/3, 4/5, 6/7, 8/9), and to give an example, 1300 and 1301 are the exact same train in Poland, with the even and odd numbers applying over different sections of its journey.
In Russia (and ex-USSR countries), the "even direction" is usually north- and eastbound, while the "odd direction" is south- and westbound. Trains travelling "even" and "odd" usually receive even and odd numbers as well as track and signal numbers, respectively.
Circumferential directions
editIn double track loop lines – such as those encircling a city – the tracks, trains and trackside equipment can be identified by their relative distance from the centre of the loop. Inner refers to the track and its trains that are closer to the geographic centre. Outer refers to the track and its trains that are furthermost from the geographic centre. One example is the City Circle line in the Sydney Trains system.
For circle routes, the directions may indicate clockwise or counterclockwise (anti-clockwise) bound trains. For example, on the Circle line of London Underground or the loop of the Central line, the directions are often referred to as "inner rail" (anti-clockwise) or "outer rail" (clockwise).
The same practice is used for circle routes in Japan, such as the Yamanote Line in Tokyo and the Osaka Loop Line, where directions are usually referred to as "outer" (
Geographical directions
editCardinal directions
editMost railroads in the United States use nominal cardinal directions for the directions of their lines, which often differ from actual compass directions. These directions are often referred to as "railroad" north, south, east, or west, to avoid confusion with the compass directions.
Typically an entire railroad system (the lines of a railroad or a related group of railroads) will describe all of its lines by only two directions, either east and west, or north and south. This greatly reduces the possibility of misunderstanding the direction in which a train is travelling as it traverses lines which may twist and turn or even reverse direction for a distance. These directions also have significance in resolving conflicts between trains running in opposite directions. For example, many railroads specify that trains of equal class running to the east are superior to those running west. This means that, if two trains are approaching a passing siding on a single-track line, the inferior westbound train must "take the siding" and wait there for the superior eastbound train to pass.
In the United States, most railroads use "east and west", and it is unusual for a railroad to designate "north and south" (the New York City Subway, the Chicago "L", and the Washington Metro are rare examples). Even-numbered trains (superior) travel east (or north). Odd-numbered trains (inferior) travel west (or south).
On the London Underground, geographic direction naming generally prevails (e.g. eastbound, westbound) except for the Circle line where it is Outer Rail and Inner Rail.
Other names for north and south
editIn New York City, the terms uptown and downtown are used in the subway to refer to northbound and southbound respectively.[8] The nominal railroad direction is determined by how the line will travel when it enters Manhattan.
For railways in China that are not connected with Beijing, north and west are used as "up", and east and south as "down". Odd numbered train codes are used for "down" trains, while even numbers are used for "up"; for example, train T27 from Beijing West to Lhasa is "down" (going away from Beijing) since 27 is odd.
References
edit- ^ Yonge, John; Padgett, David (August 2010) [1989]. Bridge, Mike (ed.). Railway Track Diagrams 3: Western (5th ed.). Bradford on Avon: Trackmaps. maps 4C, 11C. ISBN 978-0-9549866-6-7.
- ^ Train numbers
- ^ JR Timetable, March 2012 issue.
- ^ "
鐵 流 Railic on Facebook". Facebook. Archived from the original on 2022-04-30.[user-generated source] - ^ "Directional Running of Trains in QLD". Retrieved 20 July 2014.
- ^ Ferry, J. Amanda (20 May 2003). "Boston's subway". Boston Globe. Boston. Retrieved 2016-02-27.
- ^ "Muni Metro Map". The San Francisco Municipal Transportation Agency. Retrieved 31 October 2013.
- ^ "How to Ride the Subway". Metropolitan Transportation Authority. Retrieved 31 October 2013.